Avent SCF332/31 User Manual download pdf (Page 11)

Supplies needed for disinfection:

- A household pot

- High-quality drinking water

Disinfect the parts in the following way:

Fill a household pot with enough water to cover all parts. Bring the water to boil. Place the parts in the

household pot and boil them for 5 minutes (Fig. 4). During disinfection with boiling water, prevent the

bottle or other parts from touching the side of the pot. This can cause irreversible product deformation

or damage that Philips cannot be held liable for.

Allow water to cool and gently remove the parts from the water. Place the parts neatly on a clean

paper towel or in a clean drying rack and allow them to air dry. Avoid using cloth towels to dry the

parts because they can carry germs and bacteria that are harmful to your baby.

Find the best cushion for you

Expressing breast milk should be comfortable. Therefore we oer 3 soft exible cushions: a 19.5 mm

massage cushion (supplied with your breast pump), a 25 mm massage cushion and a 27 mm power

cushion. To see if the power cushion is included with your breast pump, please check the list under

section General Description.

For optimal comfort and performance, you should choose the optimal cushion for your nipples (Fig. 5).

- 19,5 mm: Massage cushion,

- 25 mm: Massage cushion (not included),

- 27 mm: Power cushion:

1 Start with the standard 19,5 mm massage cushion supplied with your breast pump. You can nd the

size of the cushion on the cushion itself (Fig. 6).

2 If the cushion is too small, purchase the larger 25 mm cushion (see ‘Ordering accessories’).

A too small cushion can cause pain or less eective expression (Fig. 7).

3 If you prefer stronger suction or if you need a larger cushion size, you can try the 27 mm power

cushion (Fig. 8).

Assembling the breast pump

Note: Make sure you have cleaned and sanitized the appropriate parts of the breast pump.

1 Wash your hands thoroughly before you handle the cleaned parts.

Warning: Be careful, the cleaned parts may still be hot. Only start assembling the

breast pump when cleaned parts have cooled down.

Note: You may nd it easier to assemble the breast pump while it is wet.

2 Insert the white valve into the pump body from underneath. Push the valve in as far as possible

(Fig. 9).

3 Screw the pump body clockwise onto the bottle until it is securely xed (Fig. 10).

4 Insert the silicone diaphragm into the pump body from above. Make sure it ts securely around the

rim by pressing down with your ngers to ensure a perfect seal (Fig. 11).

5 Insert the cushion into the funnel-shaped section of the pump body (Fig. 12).

6 Push in the inner part of the cushion as far as possible and make sure that it is perfectly sealed all

around the rim of the pump body (Fig. 13).

English

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 151 152

No comments

Avent SCF332/31 User Manual Page 11