Avent SCD481/00 User Manual download pdf (Page 9)

5 Place the parent unit within the operating range of the baby unit. Make sure it is at least 1

metre/3 feet away from the baby unit. For more information on the operating range, see

section ‘Operating range’ below (Fig. 12).



The operating range of the baby monitor is 200 metres/600 feet in open air. Depending on the

surroundings and other disturbing factors, this range may be smaller.

Dry materials Material thickness Loss of range

Wood, plaster, plaster cardboard, glass

(without metal, wires or lead)

<30cm/12in 0-10%

Brick, plywood <30cm/12in 5-35%

Reinforced concrete <30cm/12in 30-100%

Metal grilles or bars <1cm/0.4in 90-100%

Metal or aluminium sheets <1cm/0.4in 100%

For wet and moist materials, the range loss may be up to 100%.





The parent unit has a LINK light that continuously informs you of the status of the connection

between the baby unit and the parent unit. You can set an alert on the parent unit to notify you that

the connection has been lost. The parent unit beeps and the LINK light ashes red when

the connection has been lost.



1 Slide the lid of the compartment for the rechargeable pack downwards to remove it (Fig. 5).

2 Remove the rechargeable battery pack from the compartment (1) and remove the plug from

the socket (2) (Fig. 13).

3 Set the link alert switch in the compartment to the ‘on’ position (Fig. 14).

- To switch off the alert, set the link alert switch to the ‘off’ position (Fig. 15).

4 Slide the lid back onto the parent unit.



With the microphone sensitivity control on the baby unit, you can set the sound that is picked up by

the baby unit to the desired level: low, mid or high. When the microphone sensitivity is set to ‘high’,

the baby unit picks up all sounds.

Note: The sensitivity of the baby unit can only be changed when there is a connection between the baby

unit and the parent unit.

1 Set the microphone sensitivity control to the desired level (Fig. 16).

, The power-on light on the baby unit turns yellow when a sound is transmitted (Fig. 17).

Note: You can use your own voice as a sound reference.

Note: When the microphone sensitivity of the baby unit is set to ‘high’, it picks up more sounds and

therefore transmits more often. As a result, the units consume more power.

 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 171 172

Comments to this Manuals

No comments