Avent SCD481/00 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 172
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10

1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Then turn the belt clip to the left until it locks into position (‘click’) (2) (Fig. 21).

1 Turn the belt clip to the right (1) and remove it (2) (Fig. 22).

Do not immerse the baby unit, the parent unit and the parent unit charger in water and do not
clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit and the parent unit charger if they are connected to the mains.
2 Clean the baby unit, the parent unit and the parent unit charger with a damp cloth.
Make sure the baby unit and the parent unit charger are dry before you connect them to the
mains. Make sure the parent unit is dry before you put it in the parent unit charger.
3 Clean the adapters with a dry cloth.

When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and the battery pack from the parent unit.
Store the baby unit, the parent unit, the parent unit charger and the adapters in a cool and dry
place.



Only replace the batteries of the baby unit with four 1.5V R6 AA non-rechargeable batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.

Only replace the adapter of the baby unit with an adapter of the original type. You can order a new
adapter from your dealer or a Philips service centre:
- TAD1-0900200E01 / SVH-005-090-020-A1 (EU/SGP only)
- 9VD200 (AU/NZ only)


Only replace the charger of the parent unit with one of the same type.

Only replace the rechargeable battery pack of the parent unit with one of the same type.

Only replace the adapter of the parent unit charger with an adapter of the original type. You can
order a new adapter from your dealer or a Philips service centre:
- TAD1-0900200E01 / SVH-005-090-020-A1 (EU/SGP only)
- 9VD200 (AU/NZ only)
 11
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 171 172

Comments to this Manuals

No comments