Avent SCD600/00 User Manual download pdf (Page 14)

Question Answer

Why do the non-

rechargeable batteries of

the baby unit run low

quickly?

Perhaps you have switched on the nightlights. If you want to use the

nightlights, we advise you to use the baby unit on mains power.

Perhaps you are playing lullabies. The baby unit consumes a lot of

energy when you play lullabies. If you play lullabies, we advise you to

use the baby unit on mains power.

Why does the charging

time of the parent unit

exceed 3.5 hours?

The parent unit may be switched on during charging. Switch off the

parent unit during charging.

The specied operating

range of the baby

monitor is 150

metres/490 feet. Why

does my baby monitor

manage a much smaller

distance than that?

The specied range is only valid outdoors in open air. Inside your

house, the operating range is limited by the number and type of walls

and/or ceilings in between.

Why can’t I establish a

connection? Why is the

connection lost every

now and then? Why are

there sound

interruptions?

The baby unit and the parent unit are probably close to the outer

limits of the operating range or there is interference from other

2.4GHz wireless devices. Try a different location, decrease the distance

between the units or switch off other 2.4GHz wireless devices. Please

note that it takes about 5 seconds each time before a connection

between the units is established.

What happens during a

power failure?

If the parent unit is sufciently charged, it continues to operate during

a power failure. If there are batteries in the baby unit, it also continues

to operate during a power failure.

The operating time of

the parent unit is

supposed to be at least 6

hours. Why is

the operating time of my

parent unit shorter?

When the parent unit has been charged for the rst time, the

operating time is shorter because the battery has not reached its full

capacity yet. The rechargeable battery only reaches its full capacity

after you have charged and discharged it at least four times. After

this, the operating time is 6 hours if the automatic screen activation is

not activated and 8 hours if the automatic screen activation mode is

activated.

The parent unit consumes a lot of energy when the video display is

switched on continuously. Activate the automatic screen activation

mode to increase the operating time (see chapter ‘Features’, section

‘Automatic screen activation’).

The volume of the parent unit may be set too high, which causes the

parent unit to consume a lot of energy. Decrease the volume of the

parent unit

Why do I get

interference on the

parent unit?

Interference may occur when the parent unit is out of range of the

baby unit. Interference may also occur if there are too many walls or

ceilings between the parent unit and the baby unit or when other

2.4GHz wireless devices are switched on (e.g. microwave, internet).

Put the parent unit in a different place, closer to the baby unit, or

switch off other wireless devices.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 179 180

Comments to this Manuals

No comments

Avent SCD600/00 User Manual Page 14

Comments to this Manuals

Related products and manuals for Babyphones Avent SCD600/00