Avent SCD525/00 User Manual download pdf (Page 8)

• When the batteries are fully charged, the

parent unit can be used cordlessly for up

to 24 hours.

Note:



time, the operating time is less than 24 hours. The

batteries only reach their full capacity after you

have charged and discharged them four times.

Note:

When the parent unit is not in the charger, the

batteries gradually discharge, even when the

parent unit is switched off.

5 Using the appliance

1 Place the parent unit and the baby unit in the

same room to test the connection (Fig. 10).

Make sure the baby unit is at least 1 metre/3.5

feet away from the parent unit.

2 Press and hold the on/off button 3 on the

baby unit until the green power-on light goes

on. (Fig. 11)

Note:

The power-on light always lights up green,

even when there is no connection with the

parent unit.

• The nightlight lights up briey and then goes

out again.

• The battery light T lights up briey and

then goes out again. (Fig. 12)

3 Press and hold the on/off button 3 on the

parent unit until the sound level lights light up



• The display goes on and the battery symbol

appears on the display (Fig. 14).

• The LINK light ashes red and the message

‘Searching’ appears on the display. (Fig. 15)

• The LINK light on the parent unit

turns green and lights up continuously when

a connection has been established between

the baby unit and parent unit. The message

‘Linked’ appears on the display. (Fig. 16)

4.2 Parent unit

4.2.1 Operation on rechargeable batteries

The parent unit comes with two rechargeable

NiMH AAA 850mAh batteries.

Charge the parent unit before you use it for the



the batteries are low (the empty battery symbol



The parent unit starts indicating that the batteries

are low 30 minutes before the batteries are

completely empty.

Note:

If the batteries are completely empty, the parent

unit automatically switches off and loses contact

with the baby unit.

1 Remove the lid of the compartment for the

rechargeable batteries (Fig. 6).

2 Insert the rechargeable batteries (Fig. 7).

Note:

Make sure the + and - poles of the batteries

point in the right direction.

3 Reattach the lid (Fig. 8).

4 Insert the small appliance plug into the

charger, put the adapter in a wall socket and

place the parent unit in the charger (Fig. 9).

• The charging light on the charger goes on.

• The display shows a charging battery

symbol to indicate that the parent unit is

charging.

5 Leave the parent unit in the charger until the

batteries are fully charged.

• During charging, the charging light on the

charger stays on.

• When the batteries are fully charged, the

display of the parent unit shows a full

battery symbol T.

• When you charge the parent unit for



disuse, switch it off and let it charge

continuously for at least 10 hours.

• Charging normally takes 8 hours, but

it takes longer when the parent unit is

switched on while charging. To keep the

charging time as short as possible, switch

off the parent unit during charging.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 203 204

Comments to this Manuals

No comments

Avent SCD525/00 User Manual Page 8

Comments to this Manuals

Related products and manuals for Babyphones Avent SCD525/00