Avent SCD498/00 User Manual download pdf (Page 7)

Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/3

feet away).

Never place the baby unit inside the baby’s bed or playpen.

Never cover the baby monitor with a towel or blanket.

Never immerse any part of the baby monitor in water or any other liquid.

Never use the baby monitor in moist places or close to water.

Except for the battery compartments, do not open the housing of the baby unit and parent

unit in order to prevent electric shock.

Only use the adapter supplied to connect the baby unit to the mains.

Only use the charger supplied to charge the parent unit.

The adapters contain a transformer. Do not cut off the adapters to replace them with other

plugs, as this causes a hazardous situation.

If the adapter of the baby unit is damaged, always have it replaced with one of the original

type in order to avoid a hazard.

If the charger or the adapter of the charger is damaged, always have the charger replaced

with one of the original type in order to avoid a hazard.

Always place non-rechargeable batteries of the correct type in the baby unit to avoid the risk

of explosion. Always use rechargeable batteries of the correct type for the parent unit.

Since continuous transmission is prohibited, you only hear your baby when it makes sounds.



This Philips Avent appliance complies with all standards regarding electromagnetic elds (EMF). If

handled properly and according to the instructions in this user manual, the appliance is safe to use

based on scientic evidence available today.

Preparing for use

Baby unit

You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from

the mains, we advise you to insert batteries. This guarantees automatic back-up in case of mains

failure.

Mains operation

1 Put the small plug in the baby unit and put the adapter in a wall socket (Fig. 2).

Battery operation

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use

Philips LR6 PowerLife batteries.

Make sure your hands and the unit are dry when you insert the batteries.

1 Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. 3)

2 Remove the lid.

3 Insert four 1.5V R6 AA batteries (Fig. 4).

Place two batteries on top of each other and make sure the + and – poles of the batteries

point in the right direction.

4 Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with

the palm of your hand to close it. (Fig. 5)

Note: When the batteries are running low, the battery check light ( T) lights up red.

ENGLISH 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 131 132

Comments to this Manuals

No comments

Avent SCD498/00 User Manual Page 7

Comments to this Manuals

Related products and manuals for Babyphones Avent SCD498/00