Avent SCF355/00 User Manual download pdf (Page 10)

After warming test the baby food with a spoon to ensure it is

not too hot. If the baby food is not warm enough, put the

container back into the bottle warmer and warm the baby

food until it has the desired temperature.

Note: Due to the high variety of baby food consistencies, it

is strongly recommended to continuously stir and check

while you are warming the baby food for an optimal result.

Note: Due to the high variety of baby food consistencies, it

is not possible to indicate warming timings for baby food.

Using the keep warm setting to warm milk

1 Put the mains plug in the wall socket (Fig. 3).

2 Place the bottle or container in the bottle warmer (Fig. 4).

3 Fill the bottle warmer with drinking water up to the level

of the milk in the bottle/container. In case of large

amounts of milk, the maximum level of water is

approximately 1 cm below the top of the bottle warmer

(Fig. 5).

4 Select the position of keep warm (Fig. 6).

At this setting, you can warm your milk at a slow pace and

keep it warm at the right end temperature. E.g. to warm a

bottle of 4oz milk starting from room temperature, it will take

15-20min. The warming time may be longer or shorter

depends on the milk volumes and starting temperature.

Note: Philips Avent recommends to feed your baby as soon

as possible after the milk is warmed. We advise not to

reheat the milk after it has cooled down again.

Note: Always check the temperature before you feed your

baby (Fig. 9).

5 Turn the knob back to the ‘o’ position when the bottle/

container is removed from the bottle warmer (Fig. 10).

ENGLISH12

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 65 66

No comments

Avent SCF355/00 User Manual Page 10