Avent SCD603/01 User Manual download pdf (Page 14)

14

Indications on the parent unit

Why doesn’t the battery status symbol appear

on the video display of the parent unit when I

start to charge the parent unit?

• It may take a few minutes before the battery

symbol appears on the video display of the

parent unit when you charge the parent for the

rst time or after a long period of disuse.

Why do the battery/power-on light and the

battery symbol on the video display ash red?

• If the battery/power-on light and the

battery symbol on the video display ash

red,the rechargeable battery of the parent unit

is low. Connect the parent unit to an electrical

outlet to recharge the battery (see chapter

‘Preparing for use’).

Why does the parent unit beep?

• If the parent unit beeps while the out-of-

range image appears on the video display, the

connection with the baby unit is lost. Move the

parent unit closer to the baby unit.

• If the parent unit beeps while the battery/

power-on light and the battery symbol on the

video display ash red, the rechargeable battery

of the parent unit is low. Connect the parent

unit to an electrical outlet to recharge the

battery (see chapter ‘Preparing for use’).

• The baby unit may be turned off. Turn on the

baby unit.

Noise/sound

Why does the video monitor produce a high-

pitched noise?

• The units may be too close to each other. Make

sure the parent unit and the baby unit are at

least 1.5 meters (5 feet) away from each other

and set the volume to a lower level.

• The volume of the parent unit may be set too

high. Decrease the volume of the parent unit.

Can I increase the volume of the lullaby on the

baby unit?

• No, you can’t.

• Perhaps the baby unit is not connected to

an electrical outlet and the non-rechargeable

batteries in the baby unit are empty or there

are no non-rechargeable batteries in the baby

unit at all. Connect the baby unit to an electrical

outlet or put new non-rechargeable batteries

in the baby unit. Then set the on/off switch

of the baby unit to ON position to establish

connection with the parent unit.

What happens during a power failure?

• As the parent unit works on a rechargeable

battery, it continues to work if the battery is

sufciently charged. If you have placed non-

rechargeable batteries in the baby unit, the

camera continues to work and you can see

your baby.

Why do the non-rechargeable batteries of the

baby unit run low quickly?

• The baby unit consumes a lot of energy

when you have the video display turned on

continuously, when you play lullabies or when

the nightlight is turned on. We recommend to

always operate the baby unit while connected

to electricity and to use the batteries for back-

up purpose only. Do not place rechargeable

batteries in the baby unit, as they discharge

slowly even when they are not in use.

Why does the charging time of the parent unit

exceed 2.5 hours?

• The parent unit may be turned on during

charging. Turn off the parent unit during

charging.

Why do I need to keep the baby unit and its

cord at least 1 meter (3.5 feet) from my baby?

• To avoid strangulation with the cord and for

optimal sound detection, always place the baby

unit and its cord at least 1 meter (3.5 feet)

away from the baby.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments