Avent SCF356/00 User Manual download pdf (Page 10)

Note: The progress indicator shows the progress of the milk

warming process. The progress indicator starts flashing when

the appliance is on. When the first warming phase has been

completed, the bottom segment lights up continuously and

the next segment starts flashing to show that the second

warming phase is in progress. These steps continue until the

third warming phase has been completed. Then the entire

progress indicator lights up continuously.

Note: During the warming process, the milk circulates to

ensure even warming. It takes about 10 minutes to warm

90ml/3oz of room-temperature milk. It takes slightly longer

to warm cold milk or a large amount of milk.

Caution: Do not take the bottle out of the baby bottle

warmer while the progress indicator is ashing.

7 When the entire progress indicator lights up

continuously, the milk has reached the set temperature.

- When the milk is warm, you can either take the bottle out

of the baby bottle warmer to feed your baby right away

(see section ‘Feeding your baby immediately’) or you can

keep it warm in the baby bottle warmer (see section

‘Keeping milk warm’).

Increasing the milk temperature

1 If you want the milk to be warmer, you can increase the

milk temperature gradually after it is ready by switching

to milk warming setting 3 and leaving the bottle in the

appliance at the keep-warm mode (Fig. 9).

2 If you just switched o the baby bottle warmer or if it just

switched o automatically, switch it back on without

removing the warm water from it, and follow the above

step (Fig. 10).

3 The baby bottle warmer switches o automatically after

20 minutes of keep-warm mode (Fig. 11).

ENGLISH12

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 137 138

No comments

Avent SCF356/00 User Manual Page 10