Avent SCD497/00 User Manual download pdf (Page 7)

Never cover the baby monitor with a towel or blanket.

Never immerse any part of the baby monitor in water or any other liquid.

Never use the baby monitor in moist places or close to water.

Except for the battery compartments, do not open the housing of the baby unit and parent

unit in order to prevent electric shock.

Only use the adapters supplied to connect the baby unit and the parent unit to the mains.

The adapters contain a transformer. Do not cut off the adapters to replace them with other

plugs, as this causes a hazardous situation.

If the adapter of the baby unit or parent unit is damaged, always have it replaced with one of

the original type in order to avoid a hazard.

Always place non-rechargeable batteries of the correct type in the baby unit to avoid the risk

of explosion. Always use rechargeable batteries of the correct type for the parent unit.

Since continuous transmission is prohibited, you only hear your baby when it makes sounds.



This Philips Avent appliance complies with all standards regarding electromagnetic elds (EMF). If

handled properly and according to the instructions in this user manual, the appliance is safe to use

based on scientic evidence available today.

Preparing for use

Baby unit

You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from

the mains, we advise you to insert batteries. This guarantees automatic back-up in case of mains

failure.

Mains operation

1 Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. 2).

Battery operation

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use

Philips LR6 PowerLife batteries.

Make sure your hands and the unit are dry when you insert the batteries.

1 Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. 3)

2 Remove the lid.

3 Insert four 1.5V R6 AA batteries (Fig. 4).

Place two batteries on top of each other and make sure the + and – poles of the batteries

point in the right direction.

4 Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with

the palm of your hand to close it. (Fig. 5)

Note: When the batteries are running low, the battery check light ( T) on the baby unit lights up red.

Parent unit

Battery operation

The parent unit runs on two rechargeable 1.2V AAA NiMh batteries that are supplied with the

appliance.

Make sure your hands and the unit are dry when you insert the batteries.

1 Slide the battery compartment lid downwards to remove it (Fig. 6).

2 Insert the two rechargeable batteries (Fig. 7).

ENGLISH 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 155 156

Comments to this Manuals

No comments

Avent SCD497/00 User Manual Page 7

Comments to this Manuals

Related products and manuals for Babyphones Avent SCD497/00